Home > Solutions > Content

Elimination of System Error

Nano (Xi'an) Metrology Co.,Ltd | Updated: Jun 28, 2018
Source:

There are several ways to eliminate system errors
1.Error eradication, that is, eliminated from the root. Such as calibrate “HOME” before using. The manufacturing and wear error of the block can be eliminated when the measuring block is used "equant".

2. Error correction. Will verify and calculate the system error of gage in advance, to make the error table or curve, and then take the same numerical and symbolic opposite value from the system error of as the revised, Make the measured values plus the corresponding revised value to get the measuring results without system error.

QQ截图20170511152455.jpgn201805171657133788241.jpg

3. Error cancellation. This approach requires to make the measurement in a symmetric position to make the system error of the data measured in these two measurements is equal value and opposite direction. Take the average value as measured value to eliminate the fixed value system error. If the pitch of the screw thread part is measured, the pitch of the left and right tooth surfaces is measured respectively and then averaged, the system error caused by incorrect installation of the screw part during measurement can be offset.

4. Half period method. The periodic system error can be measured once every half cycle, and the average value of the data measured next to each other can be taken as a measurement value, which can effectively eliminate the periodic system error.


Please infrom us if any questions or advice

Email: overseas@cmm-nano.com



Feedback
Your comments are welcome!
For more information about our brand and products, please feel free to contact us!
Please enter your email address:
Contact us
Address: NO.55, Gongye No.2 Road, Xi'an National Civil Aerospace Base, Xi'an City, Shaanxi Province, China
Tel: +862981538937
Fax: +862989233633
E-mail: overseas@cmm-nano.com
Copyright © Nano (Xi'an) Metrology Co.,Ltd All rights reserved.