Home > Solutions > Content

Regular Tool Needed in CMM Measuring Room

Nano (Xi'an) Metrology Co.,Ltd | Updated: Apr 10, 2017
Source:

1.    Silly putty, press the work-piece and stick by hand. Cooperate with paper, feeler to see whether there is a gap.

2.    A set of gauge block, correction caliper, used to calibrate when measuring coaxial beating. Cleaned with air-laid paper or alcohol wipe to prevent rust

3.    Digital caliper. It is used when cannot confirm whether the measurement is accurate, when can avoid obvious errors

4.    Dial indicator, it is used to measure the aperture precision, it can carry out the measurement in many sections and many angles.

5.    The magnetic table. It can measure coaxial jumping, etc., and sometimes can adsorb a few small things

6.    V block, it is better can adjust the height. 

timg (2)_副本.jpg

Feedback
Your comments are welcome!
For more information about our brand and products, please feel free to contact us!
Please enter your email address:
Contact us
Address: NO.55, Gongye No.2 Road, Xi'an National Civil Aerospace Base, Xi'an City, Shaanxi Province, China
Tel: +862981538937
Fax: +862989233633
E-mail: overseas@cmm-nano.com
Copyright © Nano (Xi'an) Metrology Co.,Ltd All rights reserved.